SunStar Fortuna 5 Series - Full Function Software Method; Software Initialization and Recall; Unit Usage and Parameter Overview

10
SuiiStar
FORTUNA SERIES 5 FULL FUNCTION SOFTWARE METHOD OF USE
1) Basic Functions of the Fortuna Series 5 Full Function Software
(1) Initializing
This function is used when the user ra ndomly changes the parameter's programmed value, and forgets the original program contents.
ww®® ©®
COUNT EDGE ENTER PATTERN
Method of initializing: Tum the power on by simultaneously pressing the buttons in the figure above which are the start B/T txjtton + end B/T
button + needle plate up/down stop button.
A
Cautioij
If you initialize, all the dianges made by the user are changed to the original values programmed when the
machine was delivered from tt ie factory, therefore only dtange the value if absolutely necessary.
After initializing, rotate the machine for 1000RPM or more for approximately 5 seconds. You must make the
machine remember the location of the FILM.
(2) Sewing Machine Up/Down Stop Location Automatic Recalling Function
When first purchasing the controller, if the user steps on the pedal for 5 seconds and runs the motor before beginning the sewing work, the
machine will automatically remember the sewing machine's up/down stop location. However, when using a synchronizer this step is not
necessary.
(3) Method of Use and Functions of the Program Unit and the General Control Box's Simple Operation Box.
When there is a program unit(P/U), use it to program or change all the functions of the machine. When there is no program unit, use the
general control box operation panel to program or change all the functions of the machine.
^ For detailed information on the method of use of program units and simple operation panel refer to the explanation in the last section.
(4) Function Parameter
® Group A
(|) Group B
(3) Group C
® Group D
d) Group E
Functions
General functions of the sewing machine
All types of output, Full-on Tlme/PWM Duty, cheddng input/output operations, sewing machine models and
thread trimming sequence programming
Pedal acceleration/deceleration curve, slow starting speed and input/output port change related parameters
Al types of gain parameter related motor control
Automatic Change Function of Twin Needles Related Parameters
^ If the specific items of ft ie parameter are changed carelessly, they could cause breakdown or damage the machine. Thereftsre the
user must be well-trained before using It.
From the library of Superior Sewing Machine & Supply LLC - www.supsew.com