SunStar Fortuna 5 Series - Simple Operation Unit Part Names and Method of Use; Names of each Part in the Simple Operation Unit; Simple Program Unit Method of Use

9
SIMPLE OPERATION UNIT PART NAMES AND METHOD OF USE
1) Names of Each Part in the Simple Operation Unit
Simple operation unit is attached in the front of the control box and used when there is no program unit panel.
□□aoi
□□ODI
□□DO!
□□DDI
4-Dlgit Displayer
Qc,
D r
Start B/T Programinirtg Displayer
A Button Switch
End B/T Programming Displayer
B Button Switch
Oq.
E/Prg.
TTncad Tifnn^ and Rogratrariing Disiibyer
Button Switch for Program Changes
PresserFocR^ Up Stop and Dom) Stop PrograrninngDteplayef
D Button Switch
Needle Plata Up Stop and OoMi Stop Programming Displayer
C Button Switch
2) Simple Program Unit Method of Use
(1) Initiarizing
This function is used when the user randomly corrects the programmed value and forgets the initial programmed value.
□□DO!
□□DO!
□□DDI
□DDQI
K K
iHIo V
••
Ho W
14=
it
A i 1
1 ^
[ D E/Prg.
Tum the power on by simultaneously pressing the buttons, K1 and
A
mm
' When you Initlafize, you diange all the original values that the sevvifig rnachiie had when it was nrianufactLDed h the fe ctory.
Initialize only when absolutely necessary.
' When Inilializrg, you rnust tun the rnotor fo r rnoie than 5 seconds at the speed of 10OORPM in order to rnake the synchionizer
to work properly.
50
From the library of Superior Sewing Machine & Supply LLC - www.supsew.com