SunStar Fortuna 5 Series - Parameter Item Explanations; Group A Parameter Explanations

Suiifntar
3) Method of Use and Explanations for Specific items of the Parameter
(1) Method of Use and Explanations for Specific Items of the Group A Parameter
(General functions of sewing machine)
A Minimum/maxinfium sewing speed limit set up method and thread trimming speed set up me^od
Item No. Name of function Method of use and explanation .
A-1
Minimum sewing
speed limit set up
This Item allows user to set up the minimum sewing speed limit or the minimum sewing speed
given whenthe pedal is pressed.(20~510rpm, Initial value: 200rpm)
Ar2
Maximum sewing
speed limit set up
This item allows user to set up the mawmum sewing speed limit or the maximum sevring
speed given when the pedal is pressed.(40~9960rpm. Initial value; 4000rpm)
A-3 Thread trimming speed set up
This item allows the user to set up the thread trimming speed when Uie thread trimming
function is operating after sewing
B. Set up method of l^stitch speed by program unit(P/U) and needle plate lift/drop by button A
Item No.
Name of function Method of use and explanation ' ^ i
A-4
Setup method of
stitch speed by program unit (PAJ)
This item allows user to set up the stitch speed by program unit (P/U) and hence sets up the
stitch operating speed. However, if set up to a rapid speed, many stitches may be
sewn after pressing the button.
A-5
Set up the speed of lift/drop
of needle p^ate with button A
This item allows user to set up the speed of lift/drop of the needle plate with button A
However, if set to a rapid speed, many stitches may be sevm after pressing ti ie button.
C. Start BfT sewing speed and end BfT sewing speed set up method
Item No.
Name of function
Method of use and explanation ' |
A-7
Start B/T speed set up
This item allows user to set up the start B/T speed. If the speed is changed, the stitch
correction value also has to be set again.
AS End BfT speed set up
1
This item allows user to set up the end B/T speed. If the speed Is changed, the stitch
correction value also has to be set again.
D. Selection method of thread trimming location with pedal
Item No.
Name of function Method of use and explanation . ■'
Start BfT speed setup
You can change the thread trimming operation through pedal position by making the fsilowing
changes to the set up values.
• 0 ; When the pedal position is backward 2 gear, operate thread trimming(Starling set up value).
• 1 : When pedal position is backward 1 gear, operate Uiread trimming
• 2 : When pedal position is neutral, operate thread trimming.
E. Edge Sensor method of use Item No.
Item No. Name of function Method of use and explanation
A40 Selection of edge sensor type
The set up method changes according to the set up parfo of edge sensor
• 0; When edge is sensed and using high output sensor.
• 1; When edge is sensed and using low output sensor.
A41 Stitches performed after
edge sensor sensing
A function that programs the machine to stop after sevwng
a programmed amount of stitches when edge is sensed.
A42 Sewing speed of stitches performed
atter edge sensor sensing
A fundon that programs the sewing speed after sev/ing
a programmed amount of stitches when edge is sensed.
A46
Selection of edge sensing sewing mode
(select N-stitch mode)
A function that programs the edge sensor to operate normally,
even when other sensor signals are inputted in the edge sensor port
A
If the specific items of the parameter are changed carelessly, they could break down or damage the machine, so the
user must be well-trained before using it
From the library of Superior Sewing Machine & Supply LLC - www.supsew.com