SunStar Fortuna 5 Series - Motor Controller Setting; Setting by Machine Type

6) Motor Controller Setting
(1) Controller Setting by Machine Type
Machine Type
.rmt t
SC-7300 Series
SC-7500 Series
SC-7310 Series
^ Model Number Setting
Program Enable li
"POWER ON '+C^ i=>
IP''Enl I
Desired
Qor^ 1=^
n^na T
In
Set va ue for Parameter B-56 Model
itial Screen
3333
Parameter B Group
( P>OB ) + Q
ipmiMi
Remarks
Parameters are set according to the
ordered specifications before
machine's shipment from the
factory.
Move to B-56
©orO
"bbIIbI
(J) Before the product is shipped out from the factory, all settings are completed in line with the machine type ordered.
O In case where the controller which is different from the ordered specifications is installed to the chain-type machine:
Set the value of parameter B-56 according to the concerned machine type.
Depending on the program version of conffoller, it may not be applicable to some machines. See the following to make the
proper setting according to ff ie machine type.
^ Version display
D When the power is turned on, the CPU version is displayed as below on P/U for a moment, and then the screen moves to the initial
screen ("3333").
Classification
Program Unit
(P/U)
Handy Controller
Fortuna Series 1II(CPU version 11) Fortune Series IV(CPU version 7)
5ErH ni
SErHI I ni
This is an old version where the CPU version is not displayed.
From the library of Superior Sewing Machine & Supply LLC - www.supsew.com