SunStar Fortuna 5 Series - Detailed Sensor Functions and Control

StiiiHtar
(4) Use of Detailed Edge Sensor Functions
(D While the 0F button is being pressed, press the Q button to enter the Parameter Group
A. (Entiy into the parameter group is allowed only after trimming.)
(2) Use the and Q buttons to set the parameter numbers subject to revision. Use the 0
and 0 buttons to change parameter values.
A-Group Function Initial Value
Cpn«,r tvnp f) ° OLilput(Active High)
1: Vihen the edge is sensed, 0[\/] output(Ac6ve Low)
42 Aflerlheedgeisserjsed.sellhesfifch 3(stitches] 0-255[stitches] If^rtches)
count to {Koceed
43 After the edge is sensed, set the sewing lOOOfrpm] 20~2000(spm] 10[spm]
speed for ^stitches.
DlRn
^Fi
IDGO HP
(D Change each parameter value and save the new value by pressing the @) button.
A
1. Note that a new value is not saved wiUiout pressing the Q button after parameter value reset
2. If the system is initialized, all data is recovered back to the initial values.
(5) Edge Sensor Motion
(3) Press the *0) button to activate the edge sensor.
(2) If the edge sensor is activated, when the sewing material edge is detected, the sewing
is suspended (distance between the needle and the sewing material edge: some
20[mm]).
(2) When the sewing is suspended as in (2), move the pedal from "Neutral" to "Forward"
and then the sewing is re sumed at the stitch count set at Parameter A-42 at the speed
set at Parameter A-43.
® After completing the process (3) and conducting trimming (pedal backward), the
backtack sewing for finish (in the case where the backtack lamp is blinking) and
trimming are performed in order.
((edcs.
(6) Deactivating Edge Sensor
0 Press the 0 buton to tum off the lamp and then the edge sensor is deactivated.
From the library of Superior Sewing Machine & Supply LLC - www.supsew.com