SunStar Fortuna 5 Series - Program Unit Operation; Program Unit Part Names; Program Unit Method of Use

PROGRAM UNIT PART NAMES AND METHOD OF USE
1) Program unit part names
Stan B/T Selection Button
End BH' Selection Button
Button to Select Needle Plate Location Wtien UacMne Stops
Button to Select Presser Foot-lift Location Wtien Uacfiine Stops
Ttvead-trinvner and Wtper Selection |
2-Digt Di^iiayer
SunstarLogo
4-Digit Diailayer
BiM to Oiange ItR Sewing Speed I rstalalion
Pattern mtt CcnnectinQ Button
PATTERN
Aino Constant SaniQ Speed Selection Button
Pattern Woili Setectnn Button
1/2 SHcti Button
Button fe rCcuter Use alter Couler Progranvniig
Butem to use Edge Se/Bor Selection after Ei^ Sensor Piogramming
Button to Save Program Ctianges
2) Program Unit Method of Use
(1) 4-Digit Displayer and 2-Digit Displayer Functions and Method of Use
A. 4-Digit Displayer and 2-Digrt Displayer Functions
(D When you turn the power on, you will see a screen as shown in the fi gure.
The 4-digit displayer shows the start and end B/T sewing and the 2-digit
displayer shows the current abbreviation for the letters or numbers shown in
the 4-digit displayer (bt: the abbreviation for back tack),
<lnjtiallzing screen>
<Example of error detection>
riTiB
(2) The 4-digit displayer shows the error number for each t>-pe of error VVIWSTV
discovered and also shows the programmed value after it has been
programmed. The 2-digit displayer shows the number of the parameter <Example of selection of number 2 item in Group A>
specific item's content or name whicii is shown in the 4-digit displayer.
lunnniin^i
uuu
A
The 4-digit displayer and 2-diglt displayer show the current condition. Therefore the user should always check it
before using the machine.
From the library of Superior Sewing Machine & Supply LLC - www.supsew.com