6) Upper Thread Passing Method
After making base line of thread take-up lever to match with
U mark on the face plate by turning the sewing machine
pulley (Up stop location of need), hang the upper thread as
shown in the figure.
[ Fig. 19 ]
7) Adjusting of Stitch Number
※ Regular Sewing (Forward Sewing)
When the feed adjustment dial ① is turned right and left,
the number displayed in ② is changed. As the number
displayed in ② gets bigger, the stitches will be longer in
the case of regular sewing.
※ Condense Sewing (Backward Sewing)
When the condense adjustment dial ③ is turned right
and left, the number displayed in ④ is changed. As the
number displayed in ④ gets bigger the stitches will be
longer in the case of condense sewing. When the LED
above FWD turns on, the machine works in the regular
sewing (forward sewing) direction. And when the LED
below BWD turns on, the machine works in the backward
sewing direction.
[ Fig. 20 ]
①
②
⑤
③
④
⑥
20
To Next Page
Loading...
Need help?
General
