21
8) How to Wind the Lower Thread
A. Insert the bobbin into thread winding drive shaft ② on thread winding base ① which is installed on the upper
top.
B. Operate the machine after sticking the thread winding lever ③ to the bobbin.
C. When the thread winding lever is separated from the bobbin, cut the bobbin thread with thread winding mes
④.
[ Fig. 19 ]
9) Adjusting the Height of the Presser Foot
10) Disposing the Waste Oil
A. Unfasten presser foot screw ① with the needle bar at
the lowest position.
B. Adjust the height so that the presser foot bottom
comes 0.5mm(the thickness of the thread used)above
the sewing material. Then, tighten the screw.
When the oil receiving container at the bottom of the table
is full, take it off to empty.
[ Fig. 20 ]
[ Fig. 21 ]
①
0.5mm
Oiler
[ Caution ]
Spread out some fabrics or papers on the floor when
you attach or remove the oil receiving container
[ Caution ]
After adjusting the height of presser foot, confirm the
position of wiper
·Too excessive gap can cause jumping
·Insufficient gap can cause a failure in thread adjustment
To Next Page
Loading...
Need help?
General
