SunStar SPS/B-2516 Series - Structure of the Machine; Name of each Parts of Machine

50 pages

To Next Page

To Previous Page

Emergency Stop Switch

Pause Switch

Arm

Thread Stand

Operation

Box

Power Switch

Control Box

STRUCTURE OF THE MACHINE

1) Names of Each Parts of Machine

Sewing pedal

Upper feed plate pedal

Main Page

Table of Contents4
Machine Safety Regulations6
Machine Transportation6
Machine Installation6
Machine Repair6
Machine Operation7
Devices for Safety7
Caution Mark Position8
Contents of Marks8
Specification of Machine9
Structure of the Machine10
Name of each Parts of Machine10
Inside Structure of Control Box11
Installation of Machine12
Environment for Machine Installation12
Environment for Electricity Installation12
Assembly of Peripheral Construction Parts12
Preparation before Using the Machine15
Setting the Voltage15
How to Supply Oil16
How to Install the Needle Bar17
How to Thread the Upper Thread18
Threading the Lower Thread18
How to Take the Bobbin Case on and off18
How to Adjust the Tension of the Upper Thread and the Lower Thread19
How to Wind the Lower Thread19
Adjusting the Height of the Presser Foot20
Disposing the Waste Oil20
How to Adjust the Air Pressure20
Adjusting the Speed for Ascension and Descent of Upper Feed Plate21
How to Mount the Sewing Machine21
How to Attach and Detach V-Belt (a Series)22
Caution When Using the Floppy Disks22
How to Repair the Machine23
Adjusting the Height the Needle Bar23
Adjusting the Needle and the Shuttle23
Adjusting the Lower Shaft Gear and the Rocking Shaft Gear24
Adjusting the Spring on the Upper Side of the Shuttle24
Adjusting the Presser Foot Devices25
Adjusting the Presser Foot Lifter Cylinder27
Adjusting Accessories for Thread Delay27
Adjusting Accessories for the Wiper29
Adjusting the Trimming Parts30
Adjusting the Main Thread Control Device33
Adjusting the Upper Thread Detecting Device33
Adjusting the Hand Pulley Device33
Adjusting the Winding Device34
Adjusting the Height of Needle Plate Support Cover34
Adjusting the Height of Slider35
Adjusting the X-Guide Bracket35
Adjusting the under Feed Plate36
Adjusting the Tension of X-Timing Belt36
Setting the X-Y Origin37
Adjusting the Position of Plastic Blank38
Mounting the Direct Motor and Adjusting Method(B Series)38
Air System Circuit Diagram39
Exchanging the Fuse40
Cause of Break-Down and Troubleshooting41
Sps/B(A)-251643
Specification43
Adjusting the Angle of Upper Feed Plate(both Right and Left)43
How to Adjust the Ascending and Descending Velocity of Upper Feed Plate43
How to Use the Pedal Switch44
Air System Circuit Diagram45
Sps/B(A)-2516-Gs-20 (2246
Specification46
How to Hook the Upper Thread46
Sps/B(A)-2516-Hp(Gp)-20(2247
Specification47
How to Attach the Needle48
How to Thread the Upper Thread48
How to Thread the Lower Thread48
Adjusting the Spring on the Upper Side49
Adjusting the Moving Knife and the Fixed Knife49
Pneumatic Hook-Type Cloth Feed50
Mechanical Specifications50
How to Operate50

SunStar SPS/B-2516 Series - Structure of the Machine; Name of each Parts of Machine

Table of Contents

Related product manuals