29
8) Adjusting Accessories for the Wiper
A. Adjusting the wiper position
ⓐ Unfasten the wiper rotary shaft collar screw ① and the wiper crank screw ② when the needle tip is
19.5mm above the throat plate.
ⓑ Press the wiper rocking link ③, then adjust the wiper shaft ④ so the wiper and the needle is about
10mm apart from each other.
ⓒ Tighten the wiper rotary shaft collar screw ① and the wiper crank screw ②.
ⓓ Unfasten the wiper screw ⑤ and adjust the wiper so that the end of the wiper is about 1mm apart
from the needle end. Then, tighten the screw back on firmly.
B. Wiper operating switch
If you want to use the wiper, press the wiper
operating switch ─, if you don’t, presser
the press the wiper operating switch
O
.
[Fig. 41]
[Fig. 42]
[ Caution ]
If the wiper is not placed in the right position, the wiper may collide with the presser foot or needle
during the operation, and the wiper may not move properly.
③
②
①
⑤
→
→
10mm
1mm
19.5mm
→
→
→
→
④
Push
Needle
Plate
Wiper On/Off Switch
Wiper Off
Wiper On
To Next Page
Loading...
