12
[Fig. 1]
44
INSTALLATION OF THE MACHINE
1) Environment for Machine Installation
A. Do not use in a place where regularity voltage ± 10% is over for preventing from any accident by
wrong operation.
B. Check the indicated pressure of the devices that use atmospheric pressure such as the air cylinder to
prevent any accidents from occurring.
C. For safe operation of the machine, use the machine under the following conditions.
Surrounding Temperature During Operation : 5℃~40℃
Surrounding Temperature During Maintenance : -10℃~60℃
D. Humidity : Between 20~80%(Relative humidity)
2) Environment for Electricity Installation
A. Power voltage
·Use it within 10% change of regularity voltage.
·It is desirable to use the frequency of power within 1% of regularity frequency (50/60Hz)
B. Electric wave noise
To use with strong magnetic or high frequency goods, separate from the main power. Also do not
let the machine come close with it if possible.
C. Use low voltage when supplements or accessories are being adhered.
D. Be careful not to drop water or coffer inside of control box and motor.
E. Do not drop the control box and motor.
3) Assembly of Peripheral Construction Parts
A. Attach the X-motor cover, Y-motor cover, motor cover and belt cover to the back side of machine
with using fixing screws.
(In case of A series, place the belt cover and the X, Y cover only)
X-Motor Cover
Motor Cover
Belt Cover
Y-Motor Cover
To Next Page
Loading...
