SunStar SPS/B-2516 Series - Mounting the Direct Motor and Adjusting Method(B Series)

38
[Fig. 61]
①
①
②
②
③
Plastic Blank
20) Adjusting the position of plastic blank
After unfastening the fixing screws ① and pressing down the plastic blank handle ② to the A direction,
adjust the position of plastic blank to be adhered to a hinge pin ③, then fasten again the fixing screw ①.
21) Mounting the Direct Motor and Adjusting Method (B Series)
[Fig. 62]
Screw NO.1
Servo Motor
Flat
Surface
Upper Shaft
ARM
2
0.7
A. When you mount the coupling on the servo-motor, fit the screw No.1 of coupling to the flat surface of the
servo motor shaft and make the clearance between the coupling and servo motor 0.7mm.
B. When you mount the coupling on the upper shaft, fit the screw No.1 of coupling to the flat surface of the
upper shaft and make the clearance between the coupling and upper shaft bushing(R) 2mm.
C. After mounting both coupling, check the positions of each screws to the aligned.
※ If the positions of each screws are not aligned, the needle does not stop normal position.
Coupling
Upper Shaft
Rear
Bushing