44
[Fig. 65]
[Fig. 66]
4) How to use the pedal switch
A. Check the parameter, related to general sewing(function no.60), is set to “2”. If not, please set the
parameter to “2”.(Refer to 7.29) Change of parameter related to general sewing).
B. The pedal switch has three pedals, the right one ① moves the right upper feed plate, the intermediate one ②
moves the left upper feed plate and the left one ③ makes the sewing machine start.
C. Application (Basic)
ⓐ If you step on the intermediate pedal ②, the left upper feed plate descends to hold the sewing material.
ⓑ When you step on the right pedal ①, the right upper feed plate descends to hold the sewing material.
(When you step on the pedal ① again, the right upper feed plate ascends to the initial position)
ⓒ When both of the upper feed plates are descended, if you step on the left pedal ③, the machine starts.
※ This model does not have 2-step stroke option.
D. In case of using monolithic feed frame.
ⓐ Set the parameter, related to general sewing(function no. 60), to “0”.
ⓑ If you step on the intermediate pedal ②, the upper feed plate descends to hold the sewing material.
ⓒ After the upper feed plate descends, if you step on the left pedal ③, the machine starts sewing.
※ This model does not have 2-step stroke option.
①
③
②
①
③
②①
③
②
①
③
②
①
③
②
To Next Page
Loading...
