17
[Fig. 12]
[Fig. 13]
E. Supply silicon oil into the silicon oil tank
which is installed on the right side of the arm.
3) How to Install the Needle Bar
Unfasten the needle fixing screw on the needle
bar. Then, with the needle groove facing forward,
push the needle until the upper end touches the
needle hole of the needle bar. Fix the needle in
with the needle fixing screw.
Silicon Oil Tank
Screw
Needle
[Fig. 11]
D. Open the hook cover and supply oil till the
shuttle race ring is surrounded by oil. Put the
hook cover back on after finishing.
[ Caution ]
For safety, keep the hook cover covered during
operating.
Shuttle Race Ring
Hook Cover
To Next Page
Loading...
