35
[Fig. 56]
Y-Axis Shaft
[Fig. 55]
①
①
②
①
15) Adjusting the Height of Slider
Loosen the fixing screw ① of slide holder and adjust the gap of slider holder to be 0.3±0.2mm by
turning the slider holder with a spanner.
Pressure Plat
Pressure Plate
Slider
Slider Holder
3.5±0.2mm
16) Adjusting the X-Guide Bracket
Incline the guide bracket to the direction of “ → ”to the maximum manually. Loosen the fixing
screws for Y-transfer shaft ① and adhere the side of y-transfer shaft and the side of X-guide shaft
bracket closely, then fix the Y-transfer shaft ①.
[ Caution ]
After fixing the Y-transfer shaft screws ①, the X-guide shaft bracket should not move at all by load
even though when you move manually the feed bracket to the right and left.
Y-Guide Shaft Bracket
Y-Transfer Shaft
To Next Page
Loading...
