31
D. Unfasten the link stopper in place
ⓐ Unfasten the trimming drive link stopper
screw while trimming is not operated and
have the trimming drive link and the
trimming drive link stopper notch 0.3mm
apart from each other.
ⓑ Tighten the screw.
[Fig. 46]
[ Caution ]
If the link stopper is not set in the right
position, trimming may not be operated
correctly and the machine may be struck.
→
→
0.3mm
Thread
Trimmer
Driving
Link
Screw
Thread Trimmer
Driving Link Stopper
→
→
0.3mm
C. Setting the trimming shaft in place
ⓐ Unfasten the trimming drive link screw and the trimming shaft collar screw.
ⓑ Make the trimming shaft tip accord with part of the arm.
ⓒ Tighten the screws.
[Fig. 45]
[ Caution ]
If the position is not adjusted appropriately, trimming may not be operated correctly or the machine may
be struck.
Thread Trimmer Shaft
Thread Trimmer Cam
Screw
Thread Trimming
Driving Link
To Next Page
Loading...
