SunStar SPS/B-2516 Series - Page 5

5) Adjusting the presser foot devices 25
6) Adjusting the presser foot lifter cylinder 27
7) Adjusting accessories for thread delay 27
8) Adjusting accessories for the wiper 29
9)
Adjusting the trimming parts 30
10) Adjusting the main thread control device 33
11) Adjusting the upper thread detecting device 33
12) Adjusting the hand pulley device 33
13) Adjusting the winding device 34
14) Adjusting the height of needle plate support cover 34
15) Adjusting the height of slider 35
16) Adjusting the X-guide bracket 35
17) Adjusting the under feed plate 36
18) Adjusting the tension of X-timing belt 36
19) Setting the X-Y origin 37
20) Adjusting the position of plastic blank 38
21) Mounting the Direct Motor and Adjusting Method
(B Series) 38
22) Air System Circuit Diagram 39
23) Exchanging the Fuse 40
7. Cause of break-down and troubleshooting
41
8. SPS/B(A)-2516-HS-22
1) Specification 43
2) Adjusting the angle of upper feed plate(Both right and left) 43
3) How to adjust the ascending and descending velocity of upper feed plate 43
4) How to use the pedal switch 44
5) Air system circuit diagram 45
9. SPS/B(A)-2516-GS-20(22)
1) Specification 46
2) How to hook the upper thread 46
10. SPS/B(A)-2516-HP(GP)-20(22)
1) Specification 47
2)
How to attach the needle 48
3)
How to thread the upper thread 48
4)
How to thread the lower thread 48
5)
Adjusting the spring on the upper side 49
6)
Adjusting the moving knife and the fixed knife 49
11. Pneumatic hook-type cloth feed
1) Mechanical specifications 50
2) How to operate 50