SunSynk BB-300 - Positive Connections; Commissioning the Sunsynk Busbar; Troubleshooting and Support

SUNSYNK-BB-300 | User Manual12
Positive Connections
Before making any positive connections, make sure that the positive wires are not powered.
Disconnect all positive cables from the battery prior to connecting them to the Sunsynk
Busbar. This is to prevent accidental short circuits.
Connect all positive wires.
Power the Sunsynk Busbar system by connecting the positive battery pole(s).
Positive Connection.
COMMISSIONING THE SUNSYNK BUSBAR
Commissioning sequence:
 Check polarity of all DC cables
 Check cross sectional area of all DC cables
 Check if all cable lugs have been crimped correctly
 Check if all cable connections are tight (don’t exceed maximum torque)
 Tug slightly on each battery cable to check if the connections are tight and if the cable lugs have been
crimped correctly.
TROUBLE SHOOTING AND SUPPORT
Consult this chapter in case of unexpected behaviour or if you suspect a product fault.
The correct troubleshooting and support process is to rst consult the common issues as described in
this chapter.
Should this fail to resolve the issue, contact the point of purchase for technical support.