SUNWARD SWDM240B - Page 147

SWDM240B OPERATION & MAINTENANCE MANUAL
146
Table 7-2-1 Maintenance or Lubrication Content and Cycle
No.
Part
Measures
Maintenance cycle
1
Steel rope
Check abrasion
10 hours or every day
2
Drilling tool
Install and wear
10 hours or every day
3
Swivel joint
Regular lubrication, check
joints, mounting pin shaft for
tightness, split pin for wear
10 hours or every day
4
Transmission pulley shaft
and bearing
Regular lubrication
10 hours or every day
5
Servo-frame swing bearing
Regular lubrication and
tightness
10 hours or every day
6
Cathead main sliding frame
shaft, bearing
Regular lubrication
10 hours or every day
7
Hydraulic oil
Check oil level and hydraulic
oil quality
10 hours or every day
8
Rotary head gearbox gear
oil
Check oil level
10 hours or every day
9
Rotary head reduction
gearbox gear oil
Check oil level
10 hours or every day
10
Crowd winch reduction
gear oil
Check oil level
10 hours or every day
11
Main winch reduction
gearbox gear oil
Check oil level
10 hours or every day
12
Fuel tank
Check oil level
10 hours or every day
13
Coolant
Check liquid level
10 hours or every day
14
Engine oil level
Check oil level
10 hours or every day
15
Oil-water separator
draining
Check
10 hours or every day
16
Air intake pipe, water pipe
for loosen
Check
10 hours or every day
17
Crankcase breather
Check
10 hours or every day
18
Drive belt, fan and bolts
Check
10 hours or every day
19
Control mechanism and
meter
Check mechanical gear or
meter function
10 hours or every day
20
Each shaft, bearing, sliding
Regular lubrication
50 hours or every week