SWDM240B OPERATION & MAINTENANCE MANUAL
5 In case of abnormal equipment, you should press the emergency button immediately
and put the equipment in a safe state. The pilot or operator should report to safety
supervisor, after-sales and technical personnel immediately. Before finding the reason,
it is forbidden to start and operate the machine blindly.
6 If the weather is bad, such as heavy rain or strong wind, please stop the work
immediately(Wind speed to 10m/s），and put the equipment in a safe and stable
state(The drilling tool of rotary head is down to ground, the leader is slightly backward,
and the whole machine placed in the wind ).
7 When a storm or typhoon is forecast, the operation must be stopped in advance and the
state of the machine is processed: Use the auxiliary machine tool to stabilize the rig, or
take protective measures, for example, remove the rotary head or drop the leader.
1.6.2 Wearing Protective Devices
1 Before operation, always wear protective gear as the
work requires, this includes: tight work clothes, hard
hat, safe shoe, safety gloves
2 Safety glasses, goggles, or shield, Dust mask or
respirator
3 Please fasten your safety belt when working at high
altitude.
1.6.3 Keeping Machine Away From Power Transmission Line and Aerial
Obstacles
1 Any part or load of the machine that contact with power lines can cause casualties
2 If the machine must work in the high power line, contact the local power department in
time, cut off the power supply, and wear the protective equipment such as rubber
shoes and rubber gloves.
3 If the machine must be passed from the cable attachment, must have a signalman to
monitor the safety distance of the machine, and issue a warning in time.
4 Do not use any part of the machine or load near the power line, it must keep 5m safety
distance.
5 The machine should also be kept out of the air, especially when the rig is moving.
1.6.4 Fire Prevention
1 Prevent fire caused by leakages of fuel, hydraulic oil and lubricant.
●Check whether engine, reducer, cylinder, motor tubing and joints are damaged or flabby,
the hose is twisted, the soft/hard tube rubbing against each other, the oil cooler is damaged,
the joints are loose and all kinds of oil fluid is leaking or leaking. Check the oil leak should
use board check, cannot bare hand inspect directly. Prevent pressure oil to cut through the
To Next Page
Loading...