SUNWARD SWDM240B - Draining Water and Sediment in Diesel Tank

SWDM240B OPERATION & MAINTENANCE MANUAL
163
3）Take out the dipstick and check, the oil level should be within the range of “FULL” and
“ADD”.
4）If the oil capacity is not enough, remove the filling plug to add lubricating oil. The engine oil
filler is as FIG. 8-27.
FIG.. 7-3-14 Engine oil filler position
5）Clean lubricating oil filling plug and install it.
Warning！
Don’t take out the oil dipstick or filling plug when the engine oil is hot, because hot oil and
components is dangerous and easy to get people hurt.
7.3.12 Draining Water and Sediment in Diesel Tank
1 ） Open the drain valve by rotating it with a wrench anticlockwise to discharge water and
sediment into a suitable container (drain valve is underneath the fuel tank).
2）Close the drain valve by rotating it clockwise.
FIG. 7-3-15 Drain valve