Troubleshooting
55
Appendix
Troubleshooting
Problem Possible solution
Touch screen does not
display anything when
touched.
*Check the batteries are installed correctly.
*The batteries may be discharged. Replace
the batteries.
The SRC-7000 cannot
operate a device after
learning a function.
*Check the SRC-7000 has learned the function
correctly. Delete the code and teach the SRC-
7000 again.
*Check you used the correct remote to teach
the SRC-7000.
*The SRC-7000 cannot learn all codes. You
may not be able to program the SRC-7000 for
some devices or functions.
Cannot transmit between
two SRC-7000s (using the
optional SLC-2080 cable).
*Check the batteries in both remotes.
*Make sure the cable is connected properly.
Learning does not work. *The batteries may be discharged. Replace
the batteries.
*Check the remote is correctly aimed at the
SRC-7000’s learning eye.
*Check the remote’s IR transmitter is 5 ~ 10 cm
from the SRC-7000’s learning eye while
learning.
*Check you are holding the remote’s button
until the function is learned.
*Do not teach the SRC-7000 near
incandescent lights.
*Check the SRC-7000 has learned the function
correctly.
*The SRC-7000 cannot learn all codes. You
may not be able to program the SRC-7000 for
some devices or functions.
To Next Page
Loading...
