Overhaul Manual
O-360 and IO-360 Series Engines
AIRWORTHINESS LIMITATIONS
The Airworthiness Limitations Section is FAA
approved and specifies maintenance required
under sections 43.16 and 91.403 of the Federal
Aviation Regulations unless an alternate
program has been FAA approved. This section
is part of the type design of the O-360 and IO-
360 engine series pursuant to certification
requirements of the Federal Aviation
Regulations.
Mandatory Replacement Time
Subject to additional information contained in
FAA Approved Mandatory Service Bulletins
issued after the date of certification, the O-360
and IO-360 engine series do not contain any
components having mandatory replacement
times required for type certification.
Mandatory Inspection Intervals
Subject to additional information contained in
FAA Approved Mandatory Service Bulletins
issued after the date of certification, the O-360
and IO-360 engine series do not contain any
components having mandatory inspection
intervals other than 100 and 500 hour
inspections of magnetos as required by Unison
Slick Service Bulletin SB2-80C.
Other Mandatory Intervals or Procedures
Subject to additional information contained in
FAA Approved Mandatory Service Bulletins
issued after the date of certification, the O-360
and IO-360 engine series do not have any
inspection-related or replacement time-related
procedures required for type certification.
Distribution of Changes to Airworthiness
Limitations
Changes to this Airworthiness Limitations
Chapter constitute changes to the type design of
the O-360 and IO-360 engine series and require
FAA approval pursuant to Federal Aviation
Regulations. Such changes will be published in
FAA Approved Mandatory Service Bulletins.
Superior Vantage Engine Service Bulletins may
be obtained by writing to:
Superior Air Parts
621 South Royal Lane, Suite 100
Coppell, Texas 75019
or call: 972-829-4600
or on the web at www.superiorairparts.com
1
© March 2005 Superior Air Parts Inc.
04-00-00
Airworthiness Limitations