13
Chapter 2 Rack Mount Installation
Chapter 2
Rack Mount Installation
2.1 Overview
This chapter provides instructions for preparing and mounting your chassis in a rack. By
default, the chassis is shipped congured as a tower. The tower top cover and bottom feet
must be removed to mount in a rack. Also, the control panel/drive module should be rotated
90 degrees.
Mounting rails are optional for this system. Be sure you have received the correct rail kit for
your server.
2.2 Preparing for Rack Mounting
Choosing a Setup Location
• The system should be situated in a clean, dust-free area that is well ventilated. Avoid areas
where heat, electrical noise and electromagnetic elds are generated.
• Leave at least 25 inches clearance in front of the rack to open the front door completely.
• Leave approximately 30 inches of clearance in the back of the rack to allow for sufcient
airow and access for servicing.
• It should be a restricted access location, such as a dedicated equipment room or a service
closet.
• This product is not suitable for use with visual display workplace devices according to §2
of the German Ordinance for Work with Visual Display Units.
Rack Precautions
• Ensure that the leveling jacks on the bottom of the rack are extended to the oor so that
the full weight of the rack rests on them.
• In single rack installations, stabilizers should be attached to the rack. In multiple rack
installations, the racks should be coupled together.
• Always make sure the rack is stable before extending a server or other component from
the rack.
To Next Page
Loading...
Need help?
General
