SC826 JBOD Chassis Manual
3-2
3-3 Control Panel LEDs
There are four LEDs that provide status information about the system.
Power
The main power switch applies or removes primary power from the power supply
to the server but maintains standby power. To perform most maintenance tasks,
unplug the system to remove all power..
3-2 Control Panel Buttons
The chassis includes two push-buttons that control the system.
Power
Indicates power is being supplied to the system power supply units. This LED is
illuminated when the system is operating normally.
NIC
1
UID and IPMI Reset Button
•
• Press and hold 6 seconds to set the BMC IP address to 192.168.1.99. The
blue LED will blink.
• Press and hold 12 seconds to restore factory defaults. The blue LED will remain
on.
Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.
To Next Page
Loading...
Need help?
General
