Release : 1.1f 549 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
22.15 ip pim message-interval
This command sets the frequency at which PIM Join/Prune messages are transmitted on this PIM
interface and the no form of the command sets the default value for PIM Join/Prune message.
ip pim message-interval <Interval(0-65535)>
no ip pim message-interval
Mode
Interface Configuration Mode
Defaults
60
Example
iss (config-if)# ip pim message-interval 120
The same Join/Prune message interval must be used on all the PIM routers in the PIM
domain. If all the routers do not use the same timer interval, the performance of PIM
Sparse can be adversely affected.
Related Command
show ip pim interface – Displays the routers PIM interfaces
To Next Page
Loading...
