Release : 1.1f 715 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
27.10 neighbor - next-hop-self
This command enables BGP to send itself as the next hop for advertised routes and the no form
of the command resets the peer nexthop-self status to default. By default, Self Next Hop is
disabled.
neighbor <ip-address> next-hop-self
no neighbor <ip-address> next-hop-self
Syntax Description
ip-address - The IP address of the BGP peer
Mode
Router Configuration Mode
Defaults
By default, the next hop will be generated based on the IP address of the destination and the
present next hop in the route information.
Example
SMIS(config-router)# neighbor 23.45.0.1 next-hop-self
Administrator can use this command to make BGP speaker fill its address when advertising
routes to the BGP peer.
BGP Speaker Local AS number must be configured
Peer must have been created and peer AS must be configured
Related Commands
router bgp – Sets the AS number of the BGP Speaker
show ip bgp info – Displays the general info about BGP protocol
To Next Page
Loading...
