Supermicro SSE-X3348S - Ipv6 Rip Default-Information Originate

Release : 1.1f 817 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
30.5 ipv6 rip default-information originate
This command configures handling of default route originate and the no form of the command
disables handling of default route originate.
ipv6 rip default-information originate
no ipv6 rip default-information
Mode
Interface Configuration Mode
Example
SMIS(config-if)# ipv6 rip default-information originate
The command originates the IPv6 default route into the specified RIP routing process
updates sent out of the specified interface.
Related Command
show ipv6 rip database – Displays IPv6 Local RIB and routing protocol information