Release : 1.1f 596 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
PIM : Enabled
PIMv6 : Enabled
PIM version : 2, mode
Sparse
PIM DR : fe80::2:a00:1
PIM DR Priority : 1
PIM Neighbour Count : 0
PIM Hello/Query Interval : 150
PIM Message Interval : 200
PIM Override Interval : 0
PIM Lan Delay : 0
PIM Lan-Prune-Delay : Disabled
PIM Component Id : 1
PIM domain border : disabled
Related Commands
set ipv6 pim – Enables or disables PIMv6
ipv6 pim query-interval – Sets the frequency at which PIMv6 hello messages are
transmitted on the interface
ipv6 pim message-interval – Sets the frequency at which PIMv6 Join/Prune messages
are transmitted on the PIMv6 interface
ipv6 pim bsr-candidate – Sets the preference value for the local PIMv6 interface as a
candidate bootstrap router
ipv6 pim dr-priority – Sets the designated router priority value configured for the PIMv6
router interface
ipv6 pim override-interval – Sets the override interval configured for the PIMv6 router
interface
ipv6 pim lan-delay – Sets the LanDelay configured for the PIMv6 router interface
set ipv6 pim lan-prune-delay – Sets the LanPruneDelay bit configured for the PIMv6
router interface to advertise the lan delay
no ipv6 pim interface – Deletes an interface at PIMv6 level
debug ipv6 pim – Enables PIMv6 trace
To Next Page
Loading...
