39
Chapter 3: Maintenance and Component Installation
Figure 3-2. Installing DIMMs
X11DPU
DESIGNED IN USA
BAR CODE
IPMI CODE
CPU2
CPU1
BIOS
LICENSE
FAIL
LED
UID NIC
2 1
NIC
LED
HDDPWR
LED
X NMI
PWR
ON
JF1
RST
PS
CPU2_PORT3A
CPU2_PORT2C CPU2_PORT2A
CPU2_PORT1A
PCH_PORT1 CPU2_DMI
CPU1_PORT1A
CPU1_PORT3A
CPU1_PORT3C CPU1_PORT2A
CPU1_PORT2C
CPU2_PORT3C
REV:1.10
Installing Memory
Begin by removing power from the system as described in Section 3.1.
1. Starting with P1-DIMMA1, push the release tabs outwards on both ends of the DIMM
slot to unlock it.
Press both notches
straight down into
the memory slot.
Notches
Release Tabs
2. Align the key of the DIMM with the receptive point on the memory slot and with your
thumbs on both ends of the module, press it straight down into the slot until the module
snaps into place.
3. Press the release tabs to the locked position to secure the DIMM module into the slot.
To remove a DIMM, unlock the release tabs then pull the DIMM from the memory slot.
Caution: Exercise extreme caution when installing or removing memory modules to prevent
any possible damage to the DIMMs or slots.
Memory Installation
To Next Page
Loading...
