Supermicro SuperServer 6029U-TR25M - Control Panel

61
Chapter 4: Motherboard Connections
Figure 4-1. JF1 Control Panel Pins
Control Panel


All JF1 wires have been bundled into a single cable to simplify this connection. Make sure
the red wire plugs into pin 1 as marked on the motherboard. The other end connects to the
control panel PCB board.
NMI (Control signal)
Key
(5V standby)
(Vcc)
(Vcc)
(Vcc)
(Vcc)
(Vcc)
Reset Button (Data signal)
Power Button (Data signal)
(Ground)
Key
Power On LED (Control signal)
HDD LED (Activity signal)
NIC1 LED (Ground)
NIC2 LED (Ground)
OH/Fan Fail LED (Ground)
Power Fail LED (Ground)
(Ground)
(Ground)
2 1
20 19
Power Button
Pin Denitions (JF1)
Pin# Denition
1 Signal
2 Ground
Power Button
The Power Button connection is located on pins 1 and 2 of JF1. Momentarily contacting both

button (with a setting in the BIOS - see Chapter 6). To turn off the power when the system
is in suspend mode, press the button for 4 seconds or longer.
Reset Button
Pin Denitions (JF1)
Pin# Denition
3 Reset
4 Ground
Reset Button
The Reset Button connection is located on pins 3 and 4 of JF1. Attach it to a hardware reset
switch on the computer case.