47
Chapter 3: Maintenance and Component Installation
Checking the Server Air Flow
•
• Do not operate the server without drives or drive carriers in the drive bays.
• Use only recommended server parts.
•
The control panel LEDs display system heat status. See “Control Panel” in Chapter 1 for
details.
Overheating
There are several possible responses if the system overheats.
• Use the LEDs to determine the nature of the overheating condition.
•
• Make sure all fans are present and operating normally.
• Check the routing of the cables.
• Verify that the heatsinks are installed properly.
To Next Page
Loading...
