Supermicro SuperServer 6029U-TR25M - Page 96

SuperServer 6029U-T Series User's Manual
96
SATA RSTe Boot Info
Select Enable to provide the full int13h support for SATA controller attached devices. The
options are Disable and Enable.
Aggressive Link Power Management
When this item is set to Enable, the SATA AHCI controller manages the power usage of the
SATA link. The controller will put the link to a low power state when the I/O is inactive for an
extended period of time, and the power state will return to normal when the I/O becomes
active. The options are Disable and Enable.
SATA RAID Option ROM/UEFI Driver
Select EFI to load the EFI driver for system boot. Select Legacy to load a legacy driver for
system boot. The options are Disable, EFI, and Legacy.
SATA Port 0~ Port 7
This item displays the information detected on the installed SATA drive on the particular SATA
port.
• Model number of drive and capacity
• Software Preserve Support
Hot Plug (SATA Port 0~ Port 7)
Disable and
Enable.
Spin Up Device (SATA Port 0~ Port 7)
On an edge detect from 0 to 1, set this item to allow the PCH to initialize the device. The
options are Disable and Enable.
SATA Device Type (SATA Port 0~ Port 7)

State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State Drive.
PCH sSATA Conguration
sSATA Controller
This item enables or disables the onboard SATA controller supported by the Intel® PCH chip.
The options are Enable and Disable.
Congure sSATA as

AHCI and
RAID.