EasyManua.ls Logo

Supermicro Superserver - Appendix C System Specifications

Supermicro Superserver
134 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
128
SuperServer 1029P-WTRT User's Manual
Appendix C
System Specications
Processors
Dual Intel® Xeon® Scalable processors in an Socket P type socket
Note: 
Chipset
Intel C622 chipset
BIOS
256 MB AMI® Flash ROM
Memory
Twelve 288-pin slots that can support up to 1.5 TB of ECC DDR4-2666 RDIMM (Registered DIMM) or LRDIMM (Load-
Reduced DIMM) memory
Note: See the memory section in Chapter 3 for details and our website for updates to supported memory.
SATA Controller
On-chip (Intel C622) controller
Drive Bays
Ten 2.5" hot-swap drive bays to house eight SAS/SATA drives
PCI Expansion Slots
One PCI-E 3.0 x32 slot with riser card (RSC-R1UW-2E16)
One PCI-E 3.0 x16 slot mezzanine with SAS support
One PCI-E 3.0 x16 slot with riser card (RSC-R1UW-E8R)
Motherboard
X11DDW-NT; ATX form factor (12 x 13 in. / 305 x 330 mm.)
Chassis
SC116AC2-R706WB; 1U Rackmount, (WxHxD) 17.2 x 1.7 x 23.5 in. (437 x 43 x 597 mm)
System Cooling
Four 4-cm counter-rotating PWM fans
Power Supply
Model: PWS-706P-1R (two power modules for redundancy)
AC Input Voltages: 100-240 VAC
Rated Input Current: 8.5A to 6A
Rated Input Frequency: 50-60 Hz
Rated Output Power: 700-750W
Rated Output Voltages: +3.3V (25A), +5V (25A), +12V (700W: 58A at 100V-140V, 750W: 62A at 180V-240V), -12V (0.6A),
+5Vsb (3A)
Operating Environment
Operating Temperature: 10º to 35º C (50º to 95º F)
Non-operating Temperature: -40º to 60º C (-40º to 140º F)
Operating Relative Humidity: 8% to 90% (non-condensing)
Non-operating Relative Humidity: 5% to 95% (non-condensing)

Table of Contents

Related product manuals