Supermicro Superserver - Pch Sata Configuration

80
SuperServer 1029P-WTRT User's Manual
• Recovery Firmware Version
• ME Firmware Status #1
• ME Firmware Status #2
• Current State
• Error Code
PCH SATA Conguration
When this submenu is selected, the AMI BIOS automatically detects the presence of the
SATA devices that are supported by the Intel PCH chip and displays the following items:
SATA Controller
This item enables or disables the onboard SATA controller supported by the Intel PCH
chip. The options are Disable and Enable.
Congure SATA as


AHCI, and RAID.
SATA HDD Unlock
This feature allows the user to remove any password-protected SATA disk drives.
Aggressive Link Power Management
When this item is set to Enabled, the SATA AHCI controller manages the power usage of
the SATA link. The controller will put the link in a low power mode during extended periods
of I/O inactivity, and will return the link to an active state when I/O activity resumes. The
options are Disabled and Enabled.
*If the item above "Congure SATA as" is set to RAID, the following items will
display:
SATA Port 0 ~ Port 7
This item displays the information detected on the installed SATA drive on the particular
SATA port.
• Model number of drive and capacity
• Software Preserve Support