Supermicro X10DAL-i - System Health Monitoring

Chapter 1: Overview
1-9
System-
Health
CPU Monitoring
Monitoring
• Onboard voltage monitors for 1.05V, 1.25V, 1.5V,
+3.3V, 3.3VSB, +5V, +5V Standby, +12V, chipset,
memory, CPU1/2 vcores, and battery voltages.
• CPU/System overheat LED and control
• CPU Thermal Trip support
• Thermal Monitor 2 (TM2) support
Fan Control
• Low noise fan speed control
LED Indicators
• System/CPU Overheat LED
• Suspend-state LED
System
Management
System Management
• PECI (Platform Environment Conguration Interface)
2.0 support
• System resource alert via SuperDoctor® 5
• Thermal Monitor 2 (TM2) support
• Chassis Intrusion Header and Detection
• SuperDoctor® 5, Watch Dog, NMI
Dimensions
• 12.00" (L) x 10.00" (W) (304.80 mm x 254.00 mm)
Note: Both CPUs need to be installed for full access to the PCI-E slots,
DIMM slots, and onboard controllers. Refer to the block diagram on page
1-10 to determine which slots or devices may be affected.