Supermicro X9SRW-F - Ethernet Ports; Serial Port; Video (VGA;CRT) Connector

2-16
X9SRW Motherboard Series User’s Manual
LAN Ports
Pin Denition
Pin# Denition
1 TD0- 10 SGND
2 TD0+ 11 P3V3SB
3 TD1- 12 Act LED
4 TD1+ 13 Link 100 LED
(Green, +3V3SB)
5 TD2- 14 Link 1000 LED
(Yellow, +3V3SB)
6 TD2+ 15 Ground
7 TD3- 16 Ground
8 TD3+ 17 Ground
9 P2V5SB 88 Ground
(NC: No Connection)
1. COM1
2. IPMI LAN
3. LAN1
4. LAN2
5. VGA
1
Ethernet Ports
Two Ethernet ports (LAN1/LAN2) are
located next to the VGA port on the
I/O Backpanel. In addition, an IPMI
Dedicated LAN is also located above
USB 0/1 ports to provide a dedicated
network connection for IPMI 2.0. These
ports accept RJ45 type cables. Please
refer to the LED Indicator Section for
LAN LED information.
2
3
Video (VGA/CRT) Connector
A Video (VGA/CRT) connector is
located on the I/O backpanel. This
connector is used to provide video and
CRT display. Refer to the board layout
below for the location.
VGA
Pin Denitions
Pin# Denition Pin# Denition
1 Red 10 Ground
2 Green 11 NC
3 Blue 12 MS1: SDA (DDC Data)
4 NC 13 HSYNC
5 Ground 14 VSYSNC
6 Ground 15 MS3: SCL (DDC CLK)
7 Ground 16 Case
8 Ground 17 Case
9 5V
NC= No Connection
Serial Port
A Serial Port (COM1) is located on
the I/O backpanel. This allows serial
communication connections between
the motherboard and compatible serial
devices. See the table on the right for
pin denitions.
Serial Port Pin Denitions
(COM1)
Pin # Denition Pin # Denition
1 DCD 6 DSR
2 RXD 7 RTS
3 TXD 8 CTS
4 DTR 9 RI
5 Ground 10 NC
4
5
JF1 Header Pins