Chapter 4: AMI BIOS
4-19
be required for long and busy lines. The options are 9600, 19200,
57600, and 115200 (bits per second).
Flow Control
Use this item to set the ow control for Console Redirection to pre-
vent data loss caused by buffer overow. Send a "Stop" signal to stop
data sending when the receiving buffer is full. Send a "Start" signal
to start data sending when the receiving buffer is empty. The options
are None, Hardware RTS/CTS, and Software Xon/Xoff.
The setting for each these features is displayed:
Data Bits, Parity, Stop Bits
System Agent (SA) Configuration
The following will be displayed:
• SA PCIe Code Version
• VT-d Capability
PEG Port Conguration
PEG 0:1:0
Enable Root Port
Select Enable to activate the Root Port. The options are Disabled,
Enabled, and Auto.
To Next Page
Loading...
Need help?
General
