Chapter 4: AMI BIOS
4-29
4-5 Advanced
Boot Feature
Quiet Boot
Use this feature to select the screen display between the POST messages
and the OEM logo upon bootup. Uncheck the box to display the POST
messages. Check the box to display the OEM logo instead of the normal
POST messages.
Bootup Num-Lock
Use this feature to set the Power-on state for the <Numlock> key. The
options are Off and On.
Wait for "F1" If Error
Use this feature to force the system to wait until the 'F1' key is pressed
if an error occurs. The options are Disabled and Enabled.
Re-try Boot
If this item is enabled, the BIOS will automatically reboot the system
from a specied boot device after its initial boot failure. The options are
Disabled, Legacy Boot, and EFI Boot.
To Next Page
Loading...
Need help?
General
