Supero X10SL7-F - D-2 Steps to Reboot the System by Using Jumper JBR1; (This Option Is Not Available for this Motherboard

D-2
X10SLA/X10SLA-F User’s Manual
D-2 Steps to Reboot the System by Using Jumper JBR1
(This option is not available for this motherboard)
1. Power down the system.
2. Close pins 2-3 on Jumper JBR1, and power on the system.
3. Follow the BIOS recovery SOP listed in the previous chapter (Appendix C).
4. After completing the steps above, power down the system.
5. Close pins 1-2 on Jumper JBR1, and power on the system.