4-12
X9SKV Motherboard User’s Manual
SATA Conguration
When this submenu is selected, the AMI BIOS automatically detects the presence
of the SATA Devices and displays the following items:
•SATA Port0
•SATA Port1
SATA Mode
This item selects the mode for the installed SATA drives. The options are IDE Mode,
and AHCI ModeI, and Disabled.
If the item above -SATA Mode Selection is set to AHCI, the following items
are displayed:
Serial ATA Port 0~ Port 1
This item displays the information detected on the installed SATA drives on the
particular SATA port.
•Model number of drive and capacity
•Software Preserve Support
Staggered Spin Up
On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRE-
SET initialization sequence to the device. The options are Enabled and Disabled.
Port 0 ~ Port 1 Hot Plug
This feature designates the port specied for hot plugging. Set this item to En-
abled for hot-plugging support, which will allow the user to replace a SATA disk
drive without shutting down the system. The options are Enabled and Disabled.
PCIe/PCI/PnP Conguration
This feature allows the user to set the PCI/PnP congurations for the following items:
Above 4G Decoding
Select Enabled for 64-bit devices to be decoded above the 4GB address space
If 64bit PCI decoding is supported by the system. The options are Disabled and
Enabled.
To Next Page
Loading...
Need help?
General
