Chapter 4: AMI BIOS
4-13
VGA Palette Snoop
Select Enabled to support VGA palette register snooping which will allow the
PCI cards that do not contain their own VGA color palette to examine the video
cards palette and mimic it for proper color display. The options are Disabled and
Enabled.
PERR# Generation
Select Enabled to allow a PCI device to generate a PERR number for a PCI Bus
Signal Error Event. The options are Enabled and Disabled.
SERR# Generation
Select Enabled to allow a PCI device to generate an SERR number for a PCI Bus
Signal Error Event. The options are Enabled and Disabled.
ASPM Support
This feature congures the ASPM (Active State Power Management) settings for
the graphics device installed on the PCI-E Slot. The options are Disabled, Auto,
and Force L0s.
Onboard LAN 1, 2, 3 and 4
This setting enables or disables the onboard LAN1-LAN4 ports. The options are
Disabled and Enabled.
Onboard LAN5 / Onboard LAN6
This setting enables or disables the designated onboard LAN port. The options
are Disabled and Enabled.
Lan Bypass Setting
This option congures the motherboard's LAN Bypass feature setting. The options
are No Change, Enabled, Disabled and Passive (switch to bypass mode when
system power off).
Slot 6 PCI-E 2.0 X8 OPROM
Select Yes to enable OPROM for a PCI slot as specied. The options are Disabled,
Legacy and EFI.
Launch Storage OPROM Policy
This feature controls how the system executes UEFI (Unied Extensible Firmware
Interface), and legacy storage OPROM. Select Legacy Only to boot the system
using a legacy device installed in a PCI slot. The options are Do not launch, UEFI
only, Legacy Only, Legacy rst and UEFI rst.
To Next Page
Loading...
Need help?
General
