- 15 -
2. SAFETY PRECAUTIONS
2.1 NOTICE
2.1.1 OPERATOR
> Please read the manual carefully and put it near the edger for easy reference.
> The machine has rotating device, the wheel have potential risk, Don’t put hands near the
rotating wheels.
> Machine is heavy and need to be carried by at least 2 persons.
> When start clamping, put your hands outside of contacting area.
> Before touching the fuse, the power cord must be disconnected.
> During the installation, you must ensure that the water circuit is well sealed.
> The power plug must be unplugged before repair the edger.
2.1.2 MACHINE
> The voltage of the power supply must be in accordance with the rated voltage marked on the
label on the back of the machine. Contact the professional electricians if the voltage of the
installation site is uncertain.
> Switch located behind the machine, marked ON / OFF. Plug used to disconnect the main
power.
> When lightning or prolonged un-use, please cut off the connection with the main power
supply.
> The machine should be away from the heat sink and other heat sources which affect the
operation performance of the equipment.
> Do not obstruct and cover the vents on the carriage to ensure proper operation of the
machine.
> The machine must be installed in a well-ventilated room.
> Do not overload the socket or plug or this could cause a fire or electric shock.
> Avoid using drawn leads as power cables.
> Machine should stay away from wind and sand environment.
> Any maintenance job (need to open, close the cover) must obtain the consent of the
manufacturer or its distributor.
> Sign at different place Tips may cause the corresponding damage, should pay special
attention to.
> Controlling pump socket => electric shock hazard.
> Edging area=> physical damage.
> Water supply system => Water pressure in excess of 1 bar is dangerous.
To Next Page
Loading...
