SureTouch Refrigerated Liquid Dispensers • SureShot Technical Assistance Center: 1-888-777-9990 or 902-865-9602
4
Electrical Requirements
Power source receptacle: 120 V AC, 1 ph, 60 Hz, supports 1 amp current draw (on
220-240 V AC models: 220-240 V AC, 1 ph, 50/60 Hz, supports 1 amp current draw).
The power cord is furnished with a 3-prong attachment plug. This plug is designed to
fit a receptacle with provisions for a grounding stud. The dispenser includes a
microcontroller and must be operated on grounded electrical wiring at all times.
Failure to do so will void the Warranty.
If the power supply cord is damaged, it must be replaced by an approved cord or
assembly available from the manufacturer or its service agent.
Locating the Dispenser in Your Facility
This dispenser is not suitable for outdoor use.
Place the dispenser where it will best serve your operation.
Place the dispenser at an appropriate serving height so that users can operate the
dispenser and easily place and remove cups.
Counters, platforms or shelves must be strong enough to support the dispenser and
a full product load. See Specifications on page 3.
Do not place the dispenser too close to a source of heat or moisture.
The ambient (room) temperature range for dispenser operation is 50 ºF/10 ºC to
122 ºF/50 ºC.
Do not block the vents at the back or top of the dispenser. The vents must be free
and open to ensure proper operation of the ventilation system and to prevent over-
heating and damage to the system. Maintain a 1"/2.5 cm air space on all sides of the
dispenser.
The dispenser must be placed on a level surface. Some dispenser models have
adjustable feet and these models may be levelled by adjusting the feet. The
dispenser must be level to dispense accurate portions and to ensure proper function
of the refrigeration system. Use a bubble level to ensure the dispenser is level.
Ensure the legs are tightened in place at the four corners on the bottom of the
dispenser. Adjustable feet are threaded and may appear to be loose. Do not remove
the legs from the dispenser or allow the dispenser to sit directly on the counter. Air
flow and circulation under the dispenser is essential for proper operation of the
refrigeration system.
Note: Operating the dispenser without the legs installed automatically voids the
Warranty.
Warning: Before turning on the dispenser, make certain all installation instructions have
been followed and that the dispenser has been upright and level for a minimum of three
(3) hours.
TURNING ON THE DISPENSER
1. Plug the power cord into an approved electrical outlet.
2. Turn the power switch ON. The power switch is located at the lower left side toward
the front of the dispenser.
LOADING PRODUCT
Allow the dispenser to run empty for one hour to reach operating temperature before
loading product into the dispenser. The temperature control has been pre-set at the
factory. You can feel the cold temperature by placing your hand on the top or back
wall inside the product compartment.
To Next Page
Loading...
Need help?
General
