Suzhou Monarch Control Technology MCTC-CTB-A User Manual

Function parameter description NICE3000 User Manual
148
FE-32
Lift factory function selection1 Default 35843 Min. Unit 1
Setting Range 0～65535
This function code sets the lift factory required function. Each function is controlled by one
binary number,”1” expresses this function allowable,”0” expresses this function forbidden.
If lift needs motorman function, fire return function, inspection automatic close, car call miss-
delete, door lock jump-out inspection f
unction valid while other function invalidation, the binary
system setting is as follows:
Binary bit Function Binary setting Binary bit Function Binary setting
Bit0 Motorman 1 Bit8
Time-sharing
service oor
0
Bit1
Fire return to
main oor
1 Bit9
Independent
running
0
Bit2 Re-leveling 0 Bit10
Inspection
automatic
close door
1
Bit3 Pre-opening 0 Bit11
Car call miss
delete
1
Bit4
Hall call
conglutination
disposal
0 Bit12
Hall call miss
delete
0
Bit5
Night security
oor
0 Bit13
Emergency
auto-running
car
0
Bit6
Down
collective
sele
ctive
fastigium
service
0 Bit14
Emergency
auto-rescue
overtime
protection
0
Bit7
Fastigium
service
0 Bit15
Door lock
jump-out test
1
The setting binary number is 1000110000000011; the corresponding algorism number is 35843,
so FA-01 should be set as35843.
FE-33
Lift factory function selection2 Default 32 Min. Unit 1
Setting Range 0～65535
Factory default is forced reducer conglutination inspection function, which is listed in the
following chart.
Binary bit Function Binary setting Binary bit Function Binary setting
Bit0 Reserved 1 Bit8
N.C. output of
enclosed star
contactor
0
Bit1
Door opening
limit keep open
1 Bit9
Reversal leveling
immediate stopping
0

Suzhou Monarch Control Technology MCTC-CTB-A Specifications

General

Brand	Suzhou Monarch Control Technology
Model	MCTC-CTB-A
Category	Controller
Language	English