EasyManuals Logo

Suzhou Monarch Control Technology MCTC-CTB-A User Manual

Default Icon
183 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
NICE3000 User Manual Safety information and attention items
17
Only the qualied electrical engineer can perform the wiring, otherwise there will be

danger of electric shock.
A circuit breaker must be installed between the mains and the controller; otherwise

there will be danger of re.
Wiring can only be done after the mains input are cut off; otherwise there will be

danger of electric shock.
Please connect the controller to the ground according to the st
andard, otherwise there

will be dangerous
Do not connect the input terminals with the output terminals (U, V, W). Please note

the marks and do not connect the wrong wires otherwise the controller may be
damaged!
Ensure the wiring meet the EMC requirements and the local safety standard. The wire

size shall be determined according to the manual, otherwise accidents may occur!
Brake resistor must not be connected between the DC bus termina
ls (+) and (-),

otherwise re may occur!
Encode connection must use Shielded line, shielding layer must be one side

connected to earth reliably!
Communication wires must use STP with the length of the lay between 20mm and

30mm, shielding layer must be connected to earth!
1.1.4 before Power-on
Please conrm the mains voltage level is consistent with that of the controller ;the

input (R,S,T) and output (U,V,W) wirings are correct; and check if there is any short
circuit in peripheral circuit and if the wiring is xed and fast; otherwise the controller
may be damaged!
Ensure the synchronous motor has done the dynamic auto-tuning and try to run the

motor before restoring wire ropes.
No p
arts of controller must be through the over-voltage testing since it has been done

in the factory; Otherwise accidents will occur!
Mount the cover plate properly before power-on the controller; otherwise there will be

danger of electric shock!
All the external equipment wirings must be connected according to the instruction of

this manual, or accidents may occur!

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Suzhou Monarch Control Technology MCTC-CTB-A and is the answer not in the manual?

Suzhou Monarch Control Technology MCTC-CTB-A Specifications

General IconGeneral
BrandSuzhou Monarch Control Technology
ModelMCTC-CTB-A
CategoryController
LanguageEnglish

Related product manuals