Suzuki DF25 - Throttle Tension Adjustment; Tiller and Remote Control Model Adjustment; Idle Speed Adjustment; Idle Speed Adjustment Procedure

21
THROTTLE TENSION ADJUSTMENT
TILLER HANDLE MODEL
The tension of the throttle control grip can be
adjusted according to your preference. To
increase the tension, turn the throttle tension
adjuster A clockwise. To decrease the tension,
turn the adjuster counterclockwise.
REMOTE CONTROL MODEL
The tension of the remote control handle can be
adjusted according to your preference. To
increase the tension, turn the throttle tension
adjuster A clockwise. To decrease the tension,
turn the adjuster counterclockwise.
IDLE SPEED ADJUSTMENT
The idle speed of your outboard motor has
been set by your dealer. If it is necessary to
adjust the idle speed, use the following proce-
dure:
1. Warm up the engine for about 5 minutes.
2. Make sure that the motor is in “NEUTRAL”
and the throttle control grip is fully closed.
3. Turn the idle adjustment screw A clockwise
to increase idle speed or counterclockwise
to decrease idle speed.
NOTE:
If idle speed cannot be set within the specified
range, contact your authorized Suzuki Marine
Dealer.
Idle speed
(in Neutral)
950 – 1050
r/min. (min
–1
)