37
NOTE:
If the engine fails to start after 5 seconds, wait
10 seconds and try again.
5. After the engine has started, let it warm up
until the idle speed has stabilized.
NOTICE
If you turn the ignition key to the
“START” position for more than 5 sec-
onds, the starter system could be dam-
aged.
Never turn the ignition key to the
“START” position for more than 5 sec-
onds.
NOTICE
If you turn the ignition key to the
“START” position while the engine is run-
ning, the starter system could be dam-
aged.
Never turn the ignition key to the
“START” position while the engine is run-
ning.
NOTICE
Continuing to operate your outboard
motor with the Caution System activated
could result in severe damage to your
outboard motor.
If the caution lamp remains lit after start-
ing the engine, check the engine oil level
and add oil if necessary. If the oil level is
correct, consult your authorized Suzuki
marine dealer.
Cooling water check
As soon as the engine starts, water should
spray out of the pilot water hole 1, indicating
that the water pump and cooling system are
working properly. If you notice that water does
not spray out of the pilot water hole, stop the
engine as soon as possible and consult your
authorized Suzuki Marine Dealer.
NOTICE
Never operate your outboard motor when
there is no water coming out of the pilot
water hole, or severe damage can result.
After starting the engine, check to make
sure that there is water coming out of the
pilot water hole.
WARNING
Operating the boat when the emergency
stop switch is not operating properly can
be hazardous.
Before starting off, check to make sure
that the emergency stop switch operates
properly.
To Next Page
Loading...
