Suzuki Intruder 1978 - Page 120

5. Remove the nuts securing fan housi ng to
crankcase. Remove the fan housing and
en-
gine mount as an assembly.
6. Scribe a mark on the stator plate and the
crankcase boss for proper indexing during
reassembly. (See Figure 3-35.)
7. Remove the two screws securing the stator
plate to the crankcase. (See Figure 3-36 .)
Figure 3-
36
. ~
(j J 115
0
1314
2
- ~
4
8. Remove the stator plate. (See Figure 3-37.)
Figure
3-37
Disassembly
Refer to Figure 3-38 for disassembly sequence of
magneto components .
1. Flywhe!31
2. Stator Assembly
3. Pulser Coil
4. Pa n Head Screw
5. L ighting Coil
6. Stator Harness Clamp
7. Spri ng Washer
8. Pa n Head Screw
9. Coil Wire Clamp
10 . Exciter Coil
11 . Coil Spacer Collar
12 . Pan Head Screw
13. Plain Washer
14. Spring Washer
15. Pan Head Screw
Figure 3- 38
CDI MAGNETO 3 - 47