Figure
3-117
Figure
3-118
Reassembly
1.
Start the
wear
shoes
in
by hand then press
shoe in
until
it bottoms on
the
sheave casting.
Be
careful
when
assembling sheave
not
to
scratch and nick its face.
2. Very important: Locate the small oval protru-
sion (width
0.060
in.
(1
.5 mm). length
0.118
in.
(3.0 mm)) on the ridge on the back side
of
the
movable sheave. (See Figure
3-119
.)
Figure
3-119
3.
Place the fixed sheave onto the movable
sheave. Position the
arrow
on the fixed sheave
1500
clockw
i
se
from
the
oval protrusion,
when
viewing
from
the
splined end. Note: Check to
be sure the parts have
no
holes or dents.
4. Insert the spring. Place tang of spring into hole
marked B
in
the fixed sheave. (See Figure
3-
120
.) Apply NEVER-SEEZ to
the
splines
in
the
ramp cap.
Ins
ert
the tang on the other end of
the spring
into
hole
number
2 in the ramp cap.
(See Figure 3-
120
.) This is the standard
specification for
this
converter.
NOTE:
To
increase top end RPM move spring to
position
C-2,
which
increases
twist
to 180°.
To
de
-
crease top end RPM move spring to
A-2
(120°) or
A-1
(900) decrease of
twist.
See Chart below.
A-1
90
0
A-2 120
0
8-1
120
0
8-2 150
0
C-1
150
0
C-2
180
0
DRIVEN
CONVERTER
3-77
To Next Page
Loading...
